User manual

4. Connect the hose to a tap with a 3/4”
thread. Always use the hose supplied
with the appliance.
The inlet hose must not be lengthened.
If it is too short and you do not wish to
move the tap, you will have to purchase
a new, longer hose specially designed
for this type of use.
Installation should comply with local wa-
ter authority and building regulations re-
quirements. Check the minimum water
pressure required for safe operation of
the appliance in the chapter "Technical
Data".
Water-stop device
The inlet hose is provided with a water stop
device, which protects against damage
caused by water leaks in the hose which
could develop due to natural ageing of the
hose. This fault is shown by a red sector in
the window «A» . Should this occur, turn the
water tap off and refer to your Service Centre
to replace the hose.
Water drainage
The end of the drain hose can be positioned
in three ways:
1. Hooked over the edge of a sink using
the plastic hose guide supplied with
the machine.
In this case, make sure the end cannot
come unhooked when the machine is
emptying. This could be done by tying it
to the tap with a piece of string or attach-
ing it to the wall.
2. In a sink drain pipe branch. This
branch must be above the trap so that the
bend is at least 60 cm above the ground.
3.
Directly into a drain pipe at a height
of not less than 60 cm and not more than
90 cm.
The end of the drain hose must always be
ventilated, i.e. the inside diameter of the drain
28 electrolux