User manual

6
CLEANING THE HOSE AND NOZZLE
The vacuum cleaner stops automatically if the nozzle, tube or hose
becomes blocked, or the filters are blocked. Disconnect from the mains
and allow the vacuum cleaner to cool down for approximately 20-30 min-
utes. Clear whatever is causing the blockage and/or replace dirty
filters.Then restart the vacuum cleaner.
Tubes and hose
1. Use a cleaning strip or similiar to clear the tubes and hose.
2. It is sometimes possible to clear the hose by "massaging" it. However,
be careful in case the obstruction has been caused by glass or nee-
dles caught inside the hose.
Note: The warranty does not cover any damage to hoses caused by clean-
ing them.
Cleaning the floor nozzle
3. To avoid reduction in suction power, frequently clean the dual purpose
floor nozzle. The easiest way to clean it is by using the hose handle.
1
2
3
z71xx_ifu.qxp 2005.11.11. 11:37 Page 6