CT-24 GPS Tracker User Manual
CT-24 in Pelican Case with Magnetic Attachment, 15,600mAh Li-Ion Battery and Standalone Intelligent Battery Charger
© 2011 GPSAnyPlace , LLC Copyrights and Trademarks All rights reserved. Except as expressly provided herein, no part of this manual may be reproduced, copied, transmitted, disseminated, downloaded or stored in any storage medium, for any purpose without the express prior written consent of GPSAnyPlace, LLC.
Getting Started WARNING Please see the important safety and product Information guide in the support section of www.GPSAnyPlace.com for product warnings and other important information. NOTICE It is your responsibility to ensure that your use of this device complies with applicable laws in your area. Some jurisdictions have laws or regulations concerning the use of location tracking devices. GPSAnyPlace is not responsible for your use of this device in violation of any such laws or regulations.
Configuring the CT-24 – Done !! How to Start Tracking Your CT-24 Before you receive your CT-24 GPS tracking kit, it will have already been activated and pre-programmed by your GPS tracking service provider. This will have set up such parameters as : 1. Turn on the tracker. The Power ON/OFF switch is on the side of the CT-24. 2. Position the GPS tracker in a suitable place to receive a good GPS signal and wait for 1 to 2 minutes for the CT-24 to: a.
Charging the CT-24 Battery The CT-24 1800mAh (internal) and 15600mAh (external) 3.7V Li-Ion batteries can be charged as follows : 1. Using the CT-24 and the AC Mains Charger a. Turn-Off the CT-24. (This will speed up the charging process). b. Connect the AC Mains charger and the Battery to the CT-24. c. The LED on the CT-24 will be lit Green when the Battery is charging and will turn OFF when completed. The 1800mAh (internal) Battery will take 3½ Hours to charge via AC Mains Charger. 2.
What the LEDs Indicate : The CT-24 has 4 LEDs (lights) : Red, Blue, Green and Amber. Red LED: GSM Wireless Status Blue LED: GPS Satellite Status Flashing: Searching for GSM wireless system immediately after Power turned ON. Flashing: Searching for GPS satellite signals after Power turned ON. Constant: Connected to GSM system. Constant: Connected to at least 4 GPS satellites and the GPS position is fixed. Off : Connection lost to GSM system – out of GSM coverage area.
Amber LED: Panic Button, Low Battery and Programming Mode Slow Flashes: Low battery level. Recharge battery as soon as possible. Quick Flash: SMS text message. Quick Flash (After Quick SOS Button Press): One Flash: Vibration GPS reports Two Flashes: Fixed interval GPS reports Three Flashes: Vibration and fixed interval GPS reports. Five Quick Flashes (After 5 Second SOS Button Press): Panic Mode enabled. Constant: CT-24 connected to Programming Utility cable.
Frequently Asked Questions Care & Use: Q: How do I look after the CT-24? A: Keep it dry, away from dirt and dust and protect it from hard knocks or excessive temperature. A rubber cover, ballistic nylon belt pouch or pelican case accessory is recommended. Charging: Q: What is the best way to charge the internal 1800mAh battery ? A: Connect the AC Mains or 12V Car Cigar Charger to the CT-24, which will take about 3 hours.
Troubleshooting Problem: No Red or Blue LED’s lit on CT24 and no GPS reports received. o Possible Causes and Solutions: 1) CT-24 Turned Off. o 2) o 3) 2) Re-charge or replace battery. CT-24 has poor GPS/GSM signals. o o 4) Set Power switch to ON. Battery Discharged. Place CT-24 in location with good GPS and GSM coverage. Check if SIM card is installed and secured with tape under battery. Faulty CT-24 o Return to GPSAnyPlace Authorized Distributor for warranty repair.
CT-24 Technical Specifications GSM & GPS MODULES GSM Chipset: Siemens-Cinterion MC55i GPS Chipset: SiRFStar III GPS RECEIVER Chipset: SiRFStar III Datum: WGS-84 Sensitivity: -159dBm Reacquisition: <0.
Warranty Warranty Period GPSAnyPlace, LLC warrants their products to be free from all defects and malfunctions in materials and workmanship for a period of 12 months from the original purchase date from GPSAnyPlace, LLC or GPSAnyPlace Authorized Dealers. If the equipment functions improperly during the warranty period, GPSAnyPlace will either repair or replace the unit without charge. Such repair service will include necessary adjustments, re-manufacture, and replacements.
CT-24 Accessories Auto Voltage Adapter Kit Magnetic Reed (Open/Closed) Sensor & 6V DC Power Connector Rubber Cover with Magnetic Plate Ballistic Nylon Belt Pouch
Contact Information: Authorized Distributor: ___________________________ Address: ___________________________ ___________________________ ___________________________ Tel: Fax: Email: Website: GPS ANYPLACE, LLC. Gary Ryan – President & CEO 34719 Sykes Road Saint Helens, OR 97051 USA Sales & Marketing Tel: (503) 366-4486 Email: garyryan@gpsanyplace.com Technical Support Tel: (813) 419-4382 Email: robincobb@gpsanyplace.com Billing & Website Tel: (386) 761-6449 Email: kerry@gpsanyplace.