Model: Elite I
Multi-Channel Mixers Warnings Please be sure to read, keep and refer to instructions listed in this manual. Do not use this device near water or expose to moisture. Clean only with a dry cloth. Do not block any ventilation openings and allow adequate space for air flow during operation. Do not install near any heat sources or other devices that produce heat. Do not defeat the safety purpose of the polarized or grounding-type plug.
Multi-Channel Mixers Installation Install the mixer on an even surface to allow for sufficient airflow and ventilation during use. The device is equipped with electronically controlled cooling fans to protect against thermal overload and internal circuitry from damage due to extreme heat. Please avoid covering any sides of the unit or placing objects or other audio devices too close to your mixer.
Multi-Channel Mixers Connector Specifications Effects Connectors Effects Send - Effects Return 1/4'' TS Connector, Unbalanced Impedance: Approx. 1k Ohm Output Level: -10dB RCA Unbalanced Impedance: Approx. 1k Ohm Output Level: -10dB Control Room Outputs 1/4'' TRS Connector, Stereo Output Level: +19dB / 150 Ohm (+25dB) Headphone Output Mixer Layout and Controls - Front Panel *Please note, the diagram above does not reflect all Pyle 'Elite' Series models.
Multi-Channel Mixers 3. 4. 5. 6. GAIN CONTROL EQ CONTROL - INDEPEDANT CHANNEL EFFECT CONTROL - INDEPEDANT CHANNEL LCD DISPLAY - USB/SD CONTROL Adjust the volume for the selected channel's signal. It send the signal to the master mix buss, please remember this function allows the unit to act as a pre-amp (...so if you are using a device that has its own unique volume control, you will need to perform some volume adjustment and level matching.
Multi-Channel Mixers Mixer Layout and Controls - Back Panel 16. AC POWER The power supply cable is the standard voltage for US AC wall outlets. It is grounded and should never have the ground pin removed for any reason. 17. SPEAKER OUTPUTS 1/4'' speaker outputs (A/B). Standard 2-conductor phone jacks are wired in parallel, with each having the ability to connect to your speaker system. 18.
Multi-Channel Mixers Audio Connections and Additional Notes: We should like to draw your attention to the fact that extreme volumes may damage your hearing and/or your headphones or loudspeakers. Turn the MAIN MIX control and phones control in the main section fully down before you switch on the unit. Always be careful to set appropriate volume levels. Please, preferably, use commercial quality RCA cables to wire the inputs and outputs.
FCC WARNING This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
