User's Manual Part 2

When navigating through the wizard, the step list on the left uses a color key
to inform the user of the current step, steps that have been completed and
remaining steps.
Current Completed Remaining
3) Select the desired instrument from the dialog box to make active. If there are none
displayed, click the Scan for Instruments command button to detect all available
instruments.
If the software does not detect a M.O.L.E. Profiler, using the communication
cable connect it to the computer and click the Scan for Instruments
command button to search again. M.O.L.E.® MAP software allows multiple
instruments to be connected to a computer at one time. Selecting the Scan for
Instruments command button will detect all instruments and display them in
the dialog box. If no instrument is detected the software displays all of the
Demonstration thermal profilers to select from.
4) Click the Next command button.
5) Select the desired data run and then click the Finish command button to complete
the wizard and read the data run from the M.O.L.E. Profiler.