User's Manual

ESI RF BRIDGE User Guide DRAFT, rev 4

Regulatory Compliance

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not

cause harmful interference, and (2) this device must accept any interference received, including interference that may cause

undesired operation.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation

est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit

accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

This Class B digital apparatus complies with Canadian ICES-003.

This device complies with Industry Canada license-exempt RSS standard(s). Operation is subject to the following two conditions:

(1) this device may not cause interference, and (2) this device must accept any interference, including interference that may

cause undesired operation of the device.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the

following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to

operate the equipment.

If the equipment is used in a manner not specified by the manufacturer, the protection provided by the equipment may be

impaired.

FCC ID: P7RRFBRIDGE

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules.

IC: 7206A-RFBRIDGE

This Class B digital apparatus complies with Canadian ICES-003.

This symbol means that this product complies with the European Union Harmonised

Standards for the Low Voltage Directive and EN 60335-1: 2012

This symbol means that this product complies with International Standard EN 55011: 2007

and AS/NZS 4268: 2008

This symbol cautions the user to refer to all of the instructions and warnings specified in the

User Guide and the Installer’s Manual & Instructions before using this product.

This symbol indicates an RS-232 port.

This symbol means that this product must be disposed of separately from household waste

and must be disposed of according to local laws and regulations for electrical and electronic

waste.

Disclaimer

Information in this document is subject to change without notice. The manufacturer does not make any representations or

warranties (implied or otherwise) regarding the accuracy and completeness of this document and shall in no event be liable for

any loss of profit or any commercial damage, including but not limited to special, incidental, consequential, or other damage.