User`s manual

Playing the song again the display (in correspondence to the MIDI

channel n°2 volume) will read the value “080” until the tenth measure and

“90” after that.

This means that with the

TRKCHANG

function it is possible to set

variations that will add up (or subtract) the preset parameter values of

the songs. Such variations can be saved on the Compact Flash (in a

chart paired to the song) and will have effect only when the song is being

played not affecting the original parameters that can be recalled any

time.

Once activated TRKCHANG, the display shows a page divided in two

zones by a status bar.

The upper part concerns the managing of the single MIDI channels,

while the lower one allows to choose on which parameter to work.

The choice can be done on the following parameters:

• VOL (Volume)

• TRN (Transpose)

• PRG (Program change)

• BNK (Bank select)

• REV (Reverberation)

• CHR (Chorus)

• PAN (Panpot)

• TEMPO (metronomic time)

It is very important to understand what changers depending on the

position of the slider key: using it in the lower part it is possible to select

the parameter on which to work, being able at the same time to globally

modify it in all the MIDI channels using the adjustment knob. In that case

on the status bar the indications shown will be those of GLOBAL

followed by the name of the parameter in use and from the word

TRKCHANG. It is obviously forbidden the global regulation of PROGRAM

CHANGE and BANK SELECT

Moving the slider key to the upper part (in that case the status bar will

report the word “CHANNEL” followed by the name of the variation in use

and by the word TRKCHANG) it will be possible to adjust singularly, only

for the MIDI channel on which the slider key is positioned, the parameter

in use.