User`s manual

11
• “TEXT”: allows to access the visualization mode of chords and
lyrics.
When the M-Blaster2 is in “PLAY” (Green led above the PLAY key is
lighted) in the last line of the display the following function keys are
active:
• “TRCK ON” / “TRCK.OFF” (see above);
• “LIST” (see above);
• “TEXT” (see above);
• “TRKCHANG (TRACK CHANGE)”: allows to access the page
where to adjust the following parameters: volume, reverberation,
chorus, transposition and playing metronomic time of the song
being played.
Note: the function TRKCHANG is not available when the song is not in
“PLAY” because the adjustment values of the single parameters vary
depending on the starting value that’s preset on each song. To read the
preset starting values of each song (normally included in the first
measure of the song) it is necessary to put the song in PLAY. Pushing
twice the STOP button the effects (Rev./Delay/Chorus) come
momentarily off from MIC1/2 (“TALK” mode). The effects will
automatically reactivate when playing a song.
When a song is interrupted through the STOP button, in the last line of
the display the function TRKCHANG is replaced by:
• “CONTINUE”: it is the function which usually is coupled with the
functions Play/Stop, and it is used to restart a song exactly from
the point where it had been interrupted by the STOP button.
CHORDS AND LYRICS VISUALIZATION
The function is activated by the function key “TEXT” and it can be used
either before or after having put a song in PLAY. You can be sure not to
loose the first phrase, if you active this function before playing the song,
The underlined song contains lyrics or chords and lyrics it is sufficient to
push TEXT and then PLAY.