User's Manual

Edge 900
User’s Manual
Revised: 19 Jan 2017 3 of 9
Step 2 – Network Layout
The Edge 900 will operate in either a point to point or point to multipoint configuration. If there is only a single master and
single slave (point to point mode) the Edge 900 can devote all wireless resources to the single remote location and increase
the throughput. If programming a point to point network, select No or a multipoint network select Yes (Figure 5). Press the
Next button to proceed.
Step 3 – Serial Port Configuration
Step three will set the data rate for the serial port on the Edge 900 (Figure 6). Configure to match the connected device or
skip to step 4 if only using the Ethernet interface. Press the Next button to proceed.
Figure 5: Step 2 – Network Layout
Figure 6: Step 3 – Serial Port Configuration