User Manual Part 1

CHAPTER 3
PROGRAMMING
ESTEEM FEATURES
Revised: 15 Oct 03 3-5 EST P/N AA104
REMOTE PROGRAMMING
The Remote Programming feature allows the user to remotely program ESTeems in his network. When a connection has been
made with the remote ESTeem the RPG: prompt will be displayed showing that you are now in the COMMAND mode of that
remote ESTeem.
To enable this feature perform the following from the COMMAND MODE:
PROG (1-254) Address of destination ESTeem.
Note: You can also use the Repeater routing (r1,r2,r3,da) to reach the destination ESTeem. (r1 = address of first repeater,
r2 = address of second repeater, etc. da = destination address).
To end a remote programming session, hold Control and type C (^C) and you will return to the COMMAND prompt of your
ESTeem. There is a Watch Dog Timer that will automatically disconnect you from remote programming if there is no activity for
thirty seconds.
The REMPROG (on/off) feature is used to defeat the ability of your ESTeem from being remotely programmed. If REMPROG =
OFF another ESTeem cannot remotely program your unit. Factory default = ON.
SECURITY
The Security feature allows the user to lock out programming of the ESTeem. REMEMBER TO STORE YOUR CODE NUMBER
IN A SAFE PLACE.
To enable this feature perform the following from the COMMAND MODE:
SECURITY (1 to 100,000) Entering a security number enables the security feature.
SAVE To enter the security code permanently into the ESTeem memory.
Note: When enabled, the ESTeem will output a “Security On” message.
To disable the security feature perform the following from the COMMAND mode.
SECURITY (1 to 100,000) Entering your security number disables the security feature.
SAVE To remove the security code permanently from the ESTeem memory.
Note: When disabled, the ESTeem will output a “Security Off” message.