User Manual Part 1

CHAPTER 4
ESTEEM
APPLICATION PROGRAMS
Revised: 8 Oct 03 4-1 EST P/N AA104
Listed below are different application programs to aid the user in programming the ESTeem.
TRANSPARENT AUTO-CONNECT
This mode is used for a dedicated point to point application. The ESTeem will initiate the radio link when data is received by the
RS-232/422/485 port.
Perform the following prior to programming the ESTeem(s) to initialize the unit to factory default settings:
1. Turn Bit 2 OFF on the RS-232C Setup Switch.
2. Reset the ESTeem.
3. TYPE FA <Enter>. Please note the characters may not be echoed by the CRT.
ESTeem A ESTeem B
------------------------------ --------------------------------
ADD xxx ADD yyy
SETC yyy SETC xxx
TERMC ON TERMC ON
TERMT 10 TERMT 10
XHF ON * XHF ON *
DISACK ON * DISACK ON *
TRANS ON TRANS ON
SAVE SAVE
Bit 2 ON Bit 2 ON (RS-232 Switch)
Reset ESTeem Reset ESTeem
Notes:
• Turn DISACK ON only if you want to defeat the acknowledge packet.
• xxx and yyy represent an ESTeem address which is user definable from 1 to 254.