User Manual Part 2

APPENDIX C
ESTeem MESSAGE TABLES
Revised: 8 Oct 03 APX C-2 EST P/N AA104
ESTeem System Status Messages
Listed below are the ESTeem System Status Messages and their definitions. To receive these messages, TYPSYSTEM must be
ON (See APPENDIX D, DEFINITIONS). All System Status Messages have a bell (O7H or CTRL G) preceding the message
except when Messform is ON. If Messform = OFF Line A will be displayed. If Messform = ON Line B will be displayed.
1. A "CONNECTED TO XX"
B SSO1-xx
This message is caused by either receiving a reply
from a Log On Packet, receiving a Log On Packet, or by
typing LINK when connected and in the COMMAND
MODE. XX is the address of the modem connected to.
2. A "DISCONNECTED FROM XX"
B SSO2-xx
Tells that you have been disconnected from the device
you were originally connected to (xx is unit address).
3. A "LINK DOWN"
B SSO3
This message occurs after sending the last retry data
packet and receiving no response from the destination
node. This message usually indicates a hard failure
-i.e. destination node not energized, wrong baud rate,
(not compatible between units) improper
transmit/receive frequency between nodes, etc.
4. A "CURRENTLY NOT CONNECTED!"
B SSO4
The Disconnect was issued while the modem was not
connected to another modem or when LINK is typed in
the COMMAND MODE when you are not connected.
This message is displayed when the modem is configured in
the monitor mode.
5. A "FAILED TO CONNECT!"
B SS05
This message occurs if the modem fails to connect.
6. A "FAILED TO DISCONNECT!"
B SS06
This message occurs if the modems are connected and
are unable to disconnect.
7. A "USING FACTORY DEFAULTS"
B SS07
This command states when factory defaults have been
enabled.
8. A "REMOTE PROGRAMMING"
B SS08
This message is displayed when the ESTeem has been
placed in the remote programming mode.
9. A "PHONE MODEM CONNECTED. INFRARED
PORT DISABLED"
B SS09
This message is displayed when the ESTeem phone
port has received an in-coming call.
10. A "PHONE MODEM DISCONNECTED.
INFRARED PORT ENABLED"
B SS10
This message is displayed when the ESTeem port has
been disconnected.