User Manual Part 2

APPENDIX D
SOFTWARE COMMANDS
Revised: 13 Sep 05 APX D- 5 EST P/N AA104
GE_CTRL
This command enables the General Electric controller protocol. For further information please reference the EST Engineering
Report on General Electric controller interfacing.
ON: Enabled.
OFF: Disabled.
Factory default = OFF.
HElp
HELP switches are:
HELP Displays this Help menu.
HELP ALL Displays All commands switches and arguments.
HELP CHANGE Displays only the commands that are changed from factory default.
HELP CONTROL Displays Control commands switches and arguments.
HELP PLC Displays PLC commands switches and arguments.
HELP RADIO Displays Radio commands switches and arguments.
HELP RS-232 Displays RS232 commands switches and arguments.
HELP SETUP Displays Setup commands switches and arguments.
HELP SYSTEM Displays System commands switches and arguments.
JOHNctrl (on/off)
This function enables the Johnson controller protocol. For further detail Reference the EST Engineering Report on Johnson
controller interfacing.
ON: Enabled.
OFF: Disabled.
Factory default = OFF.
LAT
Latches the selection of the desired serial frequency synthesizer on the Tx/Rx card