User's Manual
Table Of Contents
- 195Ea Chapter 0 - Front Cover 195Ea
- 195Ea Chapter 0 - Table of Contents
- 195Ea Chapter 1 - Introduction
- 195Ea Chapter 2 - Starting Out
- 195Ea Chapter 3 - Example Applications
- 195Ea Chapter 4 - Utilities and Features
- 195Ea Chapter 5 - Web Configuration Manager
- 195Ea Chapter 6 - Serial Configuration and Applications
- 195Ea Chapter 7 - Repeating and Mesh Networking
- 195Ea Chapter 8 - Antenna Setup
- 195Ea Apx A - FCC Information
- 195Ea Apx B - Specifications
- 195Ea Apx C - Interface Ports
- 195Ea Apx D - Radio Configuration
- 195Ea Apx E - Security
- 195Ea Apx F - Troubleshooting
CHAPTER 6
SERIAL APPLICATIONS
Revised: 9 Sep 11 6-2 EST P/N AA107A
Note: All characters are lower case.
10. To set the IP address in the ESTeem 195Ea, type the letter “A” and press the Enter key. Enter the value for the IP
address, Netmask and default route pressing the Enter key after each entry.
11. After the basic parameters have been entered into the Model 195Ea you will need to commit the changes to the
Model 195Ea (Figure 3). Press the C key and then Enter. The changes will be saved to flash memory. You can
use programming features in the ESTeem Web Configuration Manager to configure the unit for your application.
Figure 2: RS-232 Welcome Screen
Figure 3: RS-232 Welcome Screen