User's Manual

CHAPTER 8
ANTENNA SETUPS
Revised: 27 Jan 12 8-1 EST P/N AA107A
ANTENNA AND CABLE CONFIGURATIONS
Warning: Only the tested cable lengths and antennas provided by EST meet the FCC and DOC maximum peak output power
requirements. Any other combination of antennas or coax cables is not authorized.
EST offers different types of antennas for both indoor and outdoor configurations. This device has been designed to operate with
the antennas listed below, and having a maximum gain of 22 dBi. Antennas not included in this list or having a gain greater than
22dBi are strictly prohibited for use with this device. The required antenna impedance is 50 ohms.
Part Number: AA20DMa
 Omni-directional direct mount antenna, 4.5 dBi gain.
 Indoor and outdoor applications.
 There must be a minimum separation distance of 23
cm. from the antenna to the user. See Warnings.
Part Number: AA20Ea
 Omni-directional external pole mount antenna, 6 dBi
gain with 18 inch integral feedline and connector.
 Outdoor applications.
 There must be a minimum separation distance of 23
cm. from the antenna to the user. See Warnings.
Part Number: AA205Ea
 Directional linear panel, pole mount antenna, 22 dBi
gain with 18 inch integral feedline, bandpass filter and
connector.
 Point to point and point to multi-point outdoor
applications.
 There must be a minimum separation distance of 50
cm. from the antenna to the user. See Warnings.
This radio transmitter (ESTeem 195Ea - 2163A-195EA) has been approved by Industry Canada to operate with the antenna types
listed above with the maximum permissible gain and required antenna impedance for each antenna type indicated. Antenna types
not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this
device.
(Le présent émetteur radio (ESTeem 195Ea – 2163A-195EA) a été approuvé par Industrie Canada pour fonctionner avec les types
d'antenne énumérés au-dessous et ayant un gain admissible maximal et l'impédance requise pour chaque type d'antenne. Les types
d'antenne non inclus dans cette liste, ou dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour
l'exploitation de l'émetteur.)
Antenna
Port A
Warnings:
Only pre-made coax cables from the factory used in
conjunction with either the omni-directional and
directional antennas meet all FCC Section 15.247(b)
EIRP maximum power requirements.
To comply with the FCC exposure compliance
requirements, a separation distance of at least ~113 cm
must be maintained between the antenna and all persons.