User's Manual Part 1

CHAPTER 3
STARTING OUT
Revised: 27 Jun 08 3-3 EST P/N AA107D
MODEL 195Ed HARDWARE CONFIGURATION
The following steps should be completed before any modifications are made to the IP address in the ESTeem Model 195Ed:
1. Connect the antenna to the antenna connector on the ESTeem Model 195Ed (Figure 3). For a single antenna use Antenna Port
A and connect both if using dual antennas.
2. Assemble the 195Ed hardware as shown in Figure 4.
Leave
Open
Single Antenna
Configuration
Dual Antenna
Configuration
Figure 3: Antenna Configuration Diagram
PC with Web
Browser Software
RJ-45 10/100BaseT
Ethernet Port
10/100BaseT
Ethernet Cable
(Patch or Cross Over)
AA175 PoE
Power Supply
LAN In
10/100BaseT
Ethernet Cable
(Patch or Cross Over)
PWR
Data Out
AA109
Resource
Disk
Figure 4: Hardware Configuration Diagram
Notes:
• Configure the Model
195Ed prior to
mounting.
• Some of the following
steps, such as
connecting the serial
cable, are easier to
perform if the ESTeem
is accessible.
• Please attach an
antenna to the Model
195Ed before power up.
• There is no Power
On/Off switch on the
Model 195Ed.