User's Manual

CHAPTER 5
EXAMPLE CONFIGURATIONS
Revised: 23 Jan 08 5-10 EST P/N AA107G
First Repeater Link
-
Enter the Wireless (WLAN) MAC
address of the stand-alone repeater site and the path cost for this link will stay at the default
value at 100. Select the level of Encryption for this communication link. The encryption levels for the repeater peer link must
be the same on both sides, but is completely independent from the Encryption level for the client access to the network. For
consistency in our example, we will also use 128-Bit WEP Encryption for the Repeater Peer link. Setting the link data rate to
Dynamic will allow all data rates from 1 Mbps to 54 Mbps to be used. Verify the Repeater Link is set to Enable and press the
Create Repeater Peer Button.
Figure 16: First (Primary) Repeater Link