User's Manual

CHAPTER 5
EXAMPLE CONFIGURATIONS
Revised: 23 Jan 08 5-11 EST P/N AA107G
Second Repeater Link (Direct Path)
-
Press the Add button a second time (Figure15) and Figure 17 will be displayed. Enter the Wireless (WLAN) MAC
address of
the Remote Building and set the path cost for this link to a value of 201. Select the level of Encryption for this communication
link. The encryption levels for the repeater peer link must be the same on both sides, but is completely independent from the
Encryption level for the client access to the network. For consistency in our example, we will also use 128-Bit WEP Encryption
for the Repeater Peer link. Setting the link data rate to Dynamic will allow all data rates from 1 Mbps to 54 Mbps to be used.
Verify the Repeater Link is set to Enable and press the Create Repeater Peer Button.
Figure 17: Second (Backup) Repeater Link