User's Manual

CHAPTER 5
EXAMPLE CONFIGURATIONS
Revised: 23 Jan 08 5-13 EST P/N AA107G
Example 2 – Stand Alone Repeater (Access Point Bridge with Repeater Enabled)
Review the example diagram, Figure 1, and locate the 195Eg marked as Example #2. This ESTeem is being used by two other
Model 195Eg’s as a repeater but is not connected to an Ethernet network. This modem should be configured for Access Point
Bridge mode.
1. Access the ESTeem Web page using your computer’s Web Browser as per instructions in Chapter 4. Select Setup from the
menu items. From the Select Mode of Operation pull down box , select AP Bridge (Figure 20) and push the Next button below
the pull down box.
2. Select if you want to use client or server Dynamic Host Configuration Protocol (DHCP) for the 195Eg. If you want to enter a
static IP address for the Model 195Eg, select Off and press the Next button. For our example, we have fixed IP addresses and
will select Off. Reference Figure 21.
Figure 20: Access Point Bridge
Figure 21: DHCP Configuration