Manual

APPENDIX D
RADIO CONFIGURATION
Revised: 16 Jun 06 APX D-2 EST P/N AA107P
RF BASIC RATE
Figure 2: Advanced Data Rate Selection
The RF Basic Rate is the synchronization rate used to establish the initial connection between 802.11g and 802.11b
communication devices in Mbps. After the initial connection has been establish the RF communication rate will be determined by
the RF Communication Data Rate established above. Factory default is 1 through 11 Mbps shown in Figure 2 so that the unity
will establish communication with the older (slower) 802.11b devices. This lower rate also allows for a quicker reconnect when
the ESTeems are configured for EtherStation mode or working in a mobile environment.
The ESTeem 195Ep is set at the factory to operate at all speeds from 1-11 Mbps and should not need adjustment. The RF Basic
Rate is programmed in the Model 195Ep through the Advanced Menu>Wireless LAN Settings>Wlan0 Device and the value for
wlan0_AP_BASICRATES:. In the example shown in Figure 2 the RF Date Rate is programmed to dynamic scale from 1 to 11
Mbps (recommend factory default setting). To set the values for the data rate, check the box next to the data rate required.
Note: The Model 195Ep will only communicate with slower speed devices after synchronization if the RF Communication Data
shown above has been set to dynamically scale to 1 and 2 Mbps.
In general, do not set the RF Basic Rates above 11Mbps unless specifically instructed by ESTeem Customer Support.