User's Manual
Table Of Contents
- Chapter 0 - Front Cover
- Chapter 0 - Table of Contents
- Chapter 1 - Introduction
- Chapter 2 - Starting Out
- Chapter 3 - Example Applications
- Chapter 4 - Utilities and Features
- Chapter 5 - Web Configuration Manager
- Chapter 6 - Serial Configuration and Applications
- Chapter 7 - Bridging and Mesh Networking
- Chapter 8 - Antenna Setup
- Apx A - Licensing Information
- Apx B - Interface Ports
- Apx C - Radio Configuration
- Apx D - Security
- Apx E - Troubleshooting
- Apx F - Horizon 2.4 Specifications
- Apx G - Horizon 900 Specifications
CHAPTER4
UTILITIES&FEATURES
Revised: 27 Jun 16 4-2 ESTeem Horizon Series
2. Onceboththeaboveprogramshavebeeninstalled,savetheESTeem.exefiletoanylocationonyourcomputer
suchastheDesktop.DoubleclicktheESTeem .e xeprogramandFigure2willbedisplayed.
3. ConnecttheHorizonmodemtoyourcomput er eitherdirectlytotheEthernetcardorthroughaSw
itchusinga
CAT‐5eEthernetcable.TheEthernetportsupportsAuto‐Negotiation,soeitherapatchcableorcrossovercable
willwork.PresstheDiscoverESTModemsbutto n.
4. The ESTeem Horizon will be displayed (Figure 3).If the ESTeem Horizon is not on the same IP subnet as the
c
omputer,doubleclickontheIP,NetmaskorGatewayandmakethenecessarychanges.PresstheApplyChanges
buttonwhencomplete.
5. IfchangesweremadetotheIPaddress,youwillneedtopresstheDiscoverESTModemsbuttonagaintoshow
thechanges.Right‐mouseclickon theHori
zonandselectConfigureRadiobuttontobeginprogramming.
Figure2:ESTeemDiscoveryUt il it y
Figure3:ESTeemDiscoveryUt il it y
Figure4:OpeningRadioConfigurationSoftware