User's Manual
Table Of Contents
- Chapter 0 - Front Cover
- Chapter 0 - Table of Contents
- Chapter 1 - Introduction
- Chapter 2 - Starting Out
- Chapter 3 - Example Applications
- Chapter 4 - Utilities and Features
- Chapter 5 - Web Configuration Manager
- Chapter 6 - Serial Configuration and Applications
- Chapter 7 - Bridging and Mesh Networking
- Chapter 8 - Antenna Setup
- Apx A - Licensing Information
- Apx B - Interface Ports
- Apx C - Radio Configuration
- Apx D - Security
- Apx E - Troubleshooting
- Apx F - Horizon 2.4 Specifications
- Apx G - Horizon 900 Specifications
APPENDIX A
LICENSING INFORMATION
Revised: 28 Jun 16 APX A-1 ESTeem Horizon Series
Information to Users
FCC Statement
The ESTeem Horizon complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Caution: Changes or modifications to this equipment not expressly approved by ESTeem Wireless Modems for compliance could
void the user's authority to operate the equipment.
IC Statement
“This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.”
“Cet appareil est conforme avec Industrie Canada exempts de licence standard RSS (s). Son fonctionnement est soumis aux
deux conditions suivantes: (1) cet appareil ne doit pas provoquer d'interférences et (2) cet appareil doit accepter toute
interférence, y compris celles pouvant causer un mauvais fonctionnement de l'appareil.”
Emissions Information
Horizon 2.4 GHz (Model 216An)
HVIN: 216AN
Direct Sequence/OFDM Spread Spectrum Device
(USA) FCC ID: ENPHZN216AN
(Canada) IC No: 2163A-216AN
Horizon 900 MHz (Model 216Ad)
HVIN: 216AD
Direct Sequence/OFDM Spread Spectrum Device
(USA) FCC ID: ENPHZN216AD
(Canada) IC No: 2163A-216AD
The equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated
in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.