User manual

3 Program 37

Record a Sequence

Test sequence

Press CLEAR three times to clear all intensities. The light in the bump button of the fader

will be dimmed in yellow to show that it has a sequence stored. It lights up at full if the fader

is above zero and contributing to the output. Select MEMS mode and move the fader for

the recorded sequence up. The sequence you recorded should appear on stage.

Action Console Feedback

1. Activate record

sequence

All buttons that can record in this mode will

blink at full in yellow. If there is a memory or

sequence stored already, this button will be

dimmed (press CLEAR to exit).

2. Choose location

(change page if desired)

... or

...

The moment the bump button is pressed, the

console will switch back into the previous

fader mode. All bump buttons that can be

used will blink at full.

3. If desired, set the time

for this step

Wheel

4. Select source for this

step

... or

...

You can select any memory or intensity

channel. Change fader page if desired.

When a bump button is pressed, that memory

or intensity will be stored as a step with the

times set in the wheels.

Repeat steps 3-4 until satisfied.

5. End recording End recording. The console will return to the

fader mode prior to recording this sequence.

Press UNDO to undo this recording.

REC

SEQ

REC

SEQ