User manual

260 Express User Manual
Installing remote video monitors
You may want to install additional monitors at remote locations . Install
monitors by connecting them to any interface devices on ETCNet. Addi-
tional monitors duplicate the master console’s displays in remote loca-
tions.
Connect monitors to interface devices by following these steps.
1. Insert the female end of the monitor power cord in the monitor con-
nector, and the male end of the monitor power cord in the interface
device connector labeled Switched outlets .
2. Connect the cable to the connector labeled CRT 1 on the interface
device.
3. Turn monitor power switch to its On position.
VGA monitor console connector
HD-DB15 female
VGA monitor pinout
1 Red video
2 Green video
3 Blue video
4 Ground
5 Ground
6 Red ground
7 Green ground
8 Blue ground
9 not connected
10 Ground
11 Ground
12 not connected
13 H. (H/V) sync
14 V. sync
15 not connected