User manual

appendix b
error messages
Diskette error messages
Bad Disk
Disk is unformatted or defective. Try formatting it. If that doesn’t work, try
a different disk.
Write-protected disk
The write-protect tab on this diskette is open. Close the tab to unprotect
the diskette.
No disk in drive
Show diskette must be inserted in the diskette drive before you can save
or read a show.
Disk controller failure
Call ETC Technical Service at 800/775-4382.
Unknown disk error - try again
Try the diskette again. If it fails again, call ETC Technical Service at 800/
775-4382.
Corrupted Disk
This disk is defective. Try formatting it. If that doesn’t work, try a different
disk.
File not found
This disk does not appear to have a show stored on it. Please confirm that
you have inserted the correct disk.
Disk full
Disk contains other files. Remove enough files to make room for show
file.
Disk access failed because of tracking failure
This message appears on the backup console in a Full Tracking Backup
system when the network or the master console fails during a diskette
operation.
Other error messages
Out of memory
You have used up all system memory allotted to the function with which
you are working. Delete unnecessary parts of the show to free up mem-
ory. If this doesn’t work, you may want to break the show into two shows,
one for each act. This message may also appear if you attempt to run too
many effects.
System Error - This software version is incompatible with the existing
hardware. Please reload the correct version of software, or contact
your service representative for further assistance.