User's Manual

3
Your administration code (Admin Code) can be found
on the back of this booklet. The Admin Code can be
changed by following instructions on page 11.
10
1. Remove Existing Deadbolt
LOCK INSTALLATION INSTRUCTIONS
2. Check Cutout Size
2 1/8”
1”
3. Install New Deadbolt
First, remove the two interior
screws securing the lock.
Next, remove the interior and
exterior lock components.
Finally, take out the existing
deadbolt slide assembly.
Place deadbolt into door, check to
see if cross-hairs are centered.
To adjust the deadbolt length,
twist the deadbolt slide assembly
to extend and center in cutout.
Make sure cross-hairs are on the
lower part of the assembly.
Check that the plate sits ush
with the door.
Secure the deadbolt plate to the
door with two short wood screws.
Cross-hairs
180°
Stop to measure the cutouts for the lock
components. If the main cutout is 2-1/8 inches
in diameter, and latch cutout is 1 inch, you're
ready to go. If not, you may need to use the
template to adjust the hole size.
Critical Point
Critical Point
Keypad Instructions
Command Press
Quiet Lock Feature
Simple Lock Feature
Master Reset Feature
2. Enter “LOCK” and press *
To turn simple lock ON, press 1,*
and repeat
To turn simple lock OFF, press 2,*
and repeat
2. Enter “SOUND” and press *
To turn sounds ON, press 1,*
and repeat
To turn sounds OFF, press 2,*
and repeat
Simultaneously
press and hold
any button and
insert the 4th
AA battery.
Enables to lock
without entering a Key Code.
Clears all stored codes
and settings.
1. Enter Admin Code
1. Enter Admin Code
Turns on/off keypad sounds
To turn off simple lock
To turn on simple lock
Enter Admin Code
L - O - C - K -
To turn off sounds
To turn on sounds
Enter Admin Code
S - O - U - N - D -
If the keypad flashes and a multi-tone alert
goes off at any point while in admin mode,
you have taken too long and will have to
start over from the first step.
L/UL Button (used for locking only)