User's Manual

5
Slide the wires above the
deadbolt slide assembly.
Insert the at bar horizontally into the
cross-hairs of the deadbolt slide assembly.
Slide wires through wire hole of
interior lock plate.
Insert two long bolts through
plate, latch, and thread into
external lock, securing all pieces
snugly.
Your administration code (Admin Code) can be found
on the back of this booklet. The Admin Code can be
changed by following instructions on page 11.
Critical Point
Critical Point
Do not skip this step or the lock
will not operate correctly.
Conrm that the deadbolt is
retracted. Note that the thumbturn at
the bottom of the interior lock is in a
horizontal position rotated away
from the deadbolt / edge of door.
6. Install Exterior Lock
7. Install Interior Plate
Attach 12-pin connector to the top of the
port on the green circuit board with the
white rectangle around it.
Attach gold tip wire connector to the gold
port on the green circuit board with the
white circle around it.
8. Attach Wires
8
Horizontal
at bar
Remote Control Keyfob Instructions
Command Press
Add Remote Control Keyfob
1. Enter Admin Code
1. Enter Admin Code
Delete an Individual Remote Control
Keyfob
Delete all Remote Control Keyfobs
2. Enter “ADD FOB”, press *
2. Enter “DEL FOBS”, press *
3. Press and hold both keyfob buttons
4. Test the keyfobs to confirm
A - D - D - F - O - B -
Press
and hold
Test
both
Enter Admin Code
Press
and hold
either
Test
both
Enter Admin Code
D - E - L - F - O - B -
Enter Admin Code
D - E - L - F - O - B - S -
4. Test the keyfob
1. Enter Admin Code
2. Enter “DEL FOB”, press *
3. Press and hold either keyfob button
4. Test the keyfob
3. Repeat “DEL FOBS”, press *
Test
both
D - E - L - F - O - B - S -