Installation guide

1
1-1 Setting up PostScript or PCL printing with Windows 98/Me
This chapter describes the procedures for installing the EX2101 software and setting
up printing from a computer using a supported version of Windows. For Windows
versions supported, see the Quick Start Guide .
The general steps for installing the software are as follows:
•Install the PostScript printer driver or PCL printer driver and corresponding printer
driver files, and set up the printer driver to communicate with the Fiery EX2101.
•Install Fiery utilities and user software—Fiery Downloader, Fiery VDP Resource
Manager, Fiery Spooler, EFI Job Monitor, Fiery Printer Delete Utility, Hot Folders,
and Command WorkStation.
• Configure the connection for Fiery utilities and user software.
• Copy additional files from the User Software CD as required.
Setting up PostScript or PCL printing with
Windows 98/Me
To set up the Fiery EX2101 as a PostScript or PCL printer, you must install the
PostScript or PCL printer driver for Windows 98/Me and the corresponding printer
description files. You must also configure either a local connection for printing directly
or a network connection for printing over the network.
N
OTE
:
Using the PostScript driver requires either the hard disk option or the PostScript
option installed on the copier.
If you are printing using SMB (Server Message Block), you can connect to the
Fiery EX2101 and install the printer drivers in a single procedure. For more
information, see “Setting up SMB printing with Windows 98/Me” on page 1-9.
Ch
apter 1:
Installing
User Software
on a Windows
Computer