Technical data

2-10 Preparing for Fiery Setup

Ensuring the copier connection

Complete the following steps before you conﬁgure the Fiery and the workstations that

will print to the Fiery. A service technician will have performed some initial

installation.

TO PREPARE FOR FIERY CONFIGURATION:

1. Print a copier test page to make sure the copier is functioning normally.

2. Turn off the copier and connect the interface cable from the copier to the Fiery.

3. To conﬁrm this connection, turn on the copier and the Fiery and print a Test Page from

the Fiery Control Panel.

To print a Test Page, press the Menu button on the Control Panel to display the

Functions menu. Choose Print Pages, and then Test Page.

4. With both the copier and the Fiery turned off, connect the network cable to the Fiery,

as described in Chapter 1.

The network should already be installed and operational.

5. Turn on the copier and then the Fiery.

6. Prepare network servers to share Fiery user software and to enable networked users to

print to the Fiery.

See Chapter 5 for details.

7. Perform Fiery Setup as described in Chapter 3.