User Manual

-110 F-110 F

-110 F

ast Response EGast Response EG

ast Response EG

T ProbeT Probe

T Probe

Important Installation InformationImportant Installation Information

Important Installation Information

All steps All steps

All steps

mustmust

must

be read before installing a probe. be read before installing a probe.

be read before installing a probe.

0720921



Note: The tab inside the male connector must be centered (not

bent up or down) to mate properly. Check each connector before

installation. Two drops of oil on the connector will protect it

from corrosion for many years.

Note: If you remove a connector, double over the wire

before installing it into a new connector. Each connector

must be double crimped very tightly.

Male Conn.

Note: If connectors have been disconnected several times the female connector may become

loose. If this happens use a pair of needle nose pliers to retighten the female receptacle

then mate the connectors.

Note: Leave slack in the

cable to allow for engine

movement and vibration.

1. Drill a .130" hole in the exhaust pipe.

Location is described in the manual.

3/8"

Ferrule

Note: Do Not Overtighten.

Over time, tight wire wraps will

cause the wire to break.

2. The slit in the ferrule must be

placed perpendicular to the Band

and the spring must be 3/8" back

from the ferrule.

Band

3. If the probe is placed in a

hole larger than .130", use a

S.S. washer between the exhaust

pipe and the ferrule.