Installation guide

Quick

Key

Option Name Description and Notes

9>5>1>1 Telephone No. Enter phone number. Use the key to enter

"T",",","P","+","*","#".

9>5>1>2 Protocol Used to define the account’s communication protocol.

For CMS accounts select one of the options: IP

protocol, SMS Contact ID, SMS SIA, SIA, Contact ID

Note: Set account 1 to IP protocol if you use GPRS

9>5>1>3 Communication

Interface

Program an account’s communication interface. Select

PSTN, GSM, or GPRS (GPRS can be used only for the

account 1)

9>5>1>4 Two-Way Audio Enable/Disable two-way audio communication

between the Control Panel and the operator at the

CMS.

9>5>1>5 Account number Enter up to eight digits. Enter leading zeros for

account numbers of less than eight digits. Use the

key to enter hexadecimal digits.

If the programmed protocol is Contact ID, "A" is not a

valid entry in the account number.

9>5>1>6 Call Attempts The Call Attempts option determines the number of

times the system tries to call a telephone number

before moving on to the next number in sequence

This feature is not available for voice report.

9>5>1>7 Account Type Select whether the account is Primary or Backup. The

first account is always primary, while every other

account (that is not a voice report) may be chosen as

primary or backup. Each primary account may have

one, several, or no backup accounts at all

Table 7: Quick keys

3.6. Set Up Follow Me Destination

Follow-Me feature is designed to notify a user an alarm event has occurred. To set up

follow me define relevant accounts as follows;

1. Enter the engineer programming menu.

2. Select [5]>[1] (Communication > Accounts)

3. Select an account to be used for Follow Me and press '√'.