Installation guide

Code

Number

Authorization

Level

Description

Master Code With the master code, you can edit all other user codes

except the Engineer code and the Central Station TWA

Code.

Caution: The default master code is 1234. Change this

code immediately after installing the system!

2-19 Controlled

Codes

When you use a controlled user code for setting and

unsetting, the control system notifies the central station

with a Set/Unset event message

20-25 Non-controlled

Codes

Non-controlled codes do not cause the system to send

Set/Unset event messages to the central station.

26-27 Limited Codes Valid only for 24 hours. These codes are "controlled"

28 Duress Code Designed for situations where the user is being forced

to operate the system.

29 Telecontrol

Code

Designed to enable the user to perform a number of

tasks via their telephone when establishing remote

connection to the system via the phone.

30 Central Station

TWA Code

Designed to enable the central station's operator to

establish two-way audio communication with the

Control System within ten minutes after an alarm or to

stop the bell.

32 Engineer Code The engineer code grants access to the programming

menu and the service menu.

Caution: The default Engineer code is 1111. Change

this code immediately after installing the system!

Table 8: Authorization level

 To Set/Edit user code

1. Go to the main menu and press '√'.

2. Enter master code (default code '1234')

3. Select '[4] User Codes'

4. Select the code to edit and press '√'.

5. The display shows '[1] Edit Code' and Press '√'.

6. Type the new code and press '√' to confirm

7. Scroll down to '[2] Descriptor' and press '√'

8. Type user name and press '√' to confirm