Installation guide

9. Press X and select another user.

10. Repeat stages 4–9 to set the code for additional users.

Notes:

To delete the code, enter: '0000'

The engineer and master codes cannot be deleted.

3.9. Set GPRS Communication

To establish GPRS communication:

1. Make sure the SIM card ID is installed inside the communication module.

Note:

If you need to install a new SIM card on the communication module and you use PIN

code, it should be programmed in the control system before inserting the SIM card in the

Main Board.

2. Edit the APN (Access Point Name) of your GPRS connection:

a. Go to the main menu and press '√'.

b. Enter engineer code (default code '1111')

c. Select [9] > [5] > [7] > [6] > [1] (Programming > Communications >

Internet > GPRS Options > APN)

d. Enter the APN name provided by the cellular provider.

e. Press '√' once editing operation is done.

Note:

To enable GPRS communication Account 1 protocol must be defined as IP and the account

interface should be defined as GPRS.

Connect to MyELAS

The Electronics Line Application Server (MyELAS) handles all communication between

the system, service providers and web users, enabling monitoring and control to be

performed via the Web or Smartphone Application. The only settings you need to

program (provided by ELAS administrator) are as follows:

Program the ELAS IP Address and Port Setting

1. Go to the main menu and press '√'.

2. Enter your engineer code.

3. Enter [9] > [5] > [7] > [1] (Programming > Communications > Internet > XMP

Proxy ID).

4. Enter the IP address of the ELAS and press '√'.

5. Enter the port setting of the ELAS and press '√'

Note:

For MyELAS, define the IP address as 195.219.118.21 and the Port setting as 33000.