Installation guide

Note

If the end user is to perform the self registration on-line then the following CPID and CP

Password steps are not required.

Program the CPID

1. Go to the main menu and press '√'.

2. Enter your engineer code.

3. Enter [9] > [5] > [7] > [3] (Programming > Communications > Internet > CPID).

4. Enter an ID using the alphanumeric keypad. The ID length is up-to 16

characters. The ID must begin with a letter.

5. Press '√'.

Program the Control Panel password

1. Go to the main menu and press '√'.

2. Enter engineer code.

3. Enter [9] > [5] > [7] > [4] (Programming > Communications > Internet > CP

Password).

4. Enter a password using the alphanumeric keypad. The password length is up

to 16 characters. The password must begin with a letter.

5. Press '√'.

If the Control Panel does not succeed to connect to the ELAS, an error message is

displayed. Table 9 indicates the optional error messages.

LCD display Trouble Description Action

MEDIA LOSS

GPRS MODULE

GPRS network fail Check the SIM card placement,

make sure it supports GPRS, and

check SIM PIN code.

Check APN definitions (Name

[95761], User name [95762] and

password [95763])

XML FAIL CP fails to communicate

with the XML Proxy

Check ELAS IP address (Quick

key [9571])

Table 9: Optional error messages