Installation guide

7
Quick
Key
Option Name Description and Notes
9>1>1>2 Zone Type The alarm this zone generates
9>1>1>3 Set Setting methods in which the zone is included.
1 (F): The zone is included in Full setting
2 (P): The zone is included in Part setting
3 (PE): The zone is included in Perimeter setting
9>1>1>4 Descriptor Descriptors help identify the device when you operate
and program the system.
9>1>1>5 Bell (Sounder) Activate the sounder when the zone is triggered
9>1>1>6 Chime Activate the internal sounder when the zone is triggered.
Note: To allow the chime option enable Global Chime
option [Quick key 7>12]
9>1>1>7 Force Set Enables to set the system even if this zone is not ready.
For the force set feature to function, you must also enable
force setting in system options.
Table 3: Parameter set
4. If required scroll thorough the other menu parameters and modify settings.
Step 3: Test the detectors
1. Go to the main menu and press
'√'.
2. Enter your engineer code (default code '1111').
3. Enter [7]>[07]>[2] (Service > Transmitters > TX Test) to initiate the TX
communication test. This test enables to identify transmitters and test their
signal strength.
4. Activate the transmitter to test; the transmitter’s details appear on the
CommPact LCD and a sequence of tones is heard indicating the transmitter’s
signal strength.
Signal Strength Tones
Note:
If the signal strength is less
than 6, place the devices in
a better location.
0-2 1 Tone
3-5 2 Tones
6-8 3 Tones
8-9 4 Tones
Table 4: Signal strength