User manual

-3-
Quick Reference Guide
Function Press Additional Information
SET
If “One-Key Setting” is disabled enter your user
code when setting.
The default Master code is 1234.
INSTANT SET
Hold down this key until
“Instant Setting OK?” is
displayed. Then Press √.
Instant setting cancels the entry delay after Part or
Perimeter setting. This feature can be enabled by
your engineer.
UNSET [USER CODE]
Entering your user code also silences the sounder
in the event of an alarm.
PANIC
ALARM
+
Press these keys together and hold them down to
generate an alarm.
FIRE
ALARM
+
MEDICAL
ALARM
+
MENU MODE
then [USER CODE]
Use the menu navigation keys (/) until the required
menu item is displayed then press √. Alternatively, enter
the shortcut (e.g. 21 for Omit Zones).
CHECK
TROUBLE
CONDITIONS
Use this key scroll the
system trouble list
Pressing  also silences any trouble tones that
may be sounded by the system.
SWITCH HA/PGM
UNIT ON
then [HA UNIT #]
Enter the HA module number in two digits
(e.g. 03, or 30 for PGM ).
SWITCH HA/PGM
UNIT OFF
then [HA UNIT #]
SERVICE CALL
Hold down this key until
“Service Call Dialing” is
displayed.
The number dialed for the service call is
programmed by your engineer.
GLOBAL
CHIME
then
Use the menu navigation keys (/) to choose
enable or disable, then press √.
RECORD
MESSAGE
then
After recording a message, “Message Waiting” is
displayed until the message is played back.
The Message Center is an optional feature that is
included with certain versions of infinite prime.
PLAY
MESSAGE
then
Telecontrol Commands
Function Press Function Press
2-WAY AUDIO
UNSET
FULL SET
SOUNDER CANCEL
HA UNIT XX ON
*
then
EXTEND CALL
HA UNIT XX OFF*
then
DISCONNECT
then
*
for PGM XX=30
OR OR