Installation manual

-23-
Address 74: Primary Communication Protocol
Address 75: Duplicate Communication Protocol
Address 76: Backup Communication Protocol
Telephone numbers
Address 77: Primary Telephone Number
The Primary 1 telephone number is the first number that is dialed when an event occurs.
You can enter a maximum of 16 digits at this address. To add a two-second pause, enter
B (
4, 1). To switch from pulse to DTMF dialing enter E (4, 4). To add a “4", enter (4, 4).
To add a “#”, enter (
4, #). These additional digits are included in the 16 digit total. Press
ENTER after you program the last digit of the telephone number.
Address 78: Duplicate Telephone Number
The Duplicate telephone number enables the control panel to report events to more than
one central station. The Duplicate telephone number is programmed in the same way as
the Primary telephone number (address 77).
Address 79: Backup Telephone Number
If the panel fails to communicate with either the Primary or Duplicate numbers within a
communication round, the Backup telephone number is dialed. The Backup telephone
number is programmed in the same way as the Primary telephone number (address 77).
Address 80: RP Callback Telephone Number
Remote programming communication can be established using two methods, passcode
and callback (see address 02, second digit). If RP callback is selected the panel receives
a call from the remote programmer, hangs up and calls back using the telephone number
programmed at this address. The RP callback telephone number is programmed in the
same way as the Primary telephone number (address 77).
Note: To disable a telephone number, enter the appropriate address and press ENTER. It is
not possible to program a backup number unless a primary number has been programmed.
Address 81: RP Access Code
This 4-digit code grants access to the remote programmer.
Note: Do not enter Hex digits.
Address 82: Account Number
When an event code is sent, the central station receives an account number to identify
the customer. Enter a 4-digit account number at this address.
Address 83: Installer Code
The installer code is a 4-digit code which grants access to programming mode. The
default for this code (1234) should be changed immediately after installing the system.
Note: Do not enter Hex digits.