Installation manual

-27-
E
Entry Delay
See Delay
Event Code
The two-digit code transmitted to the central station to indicate that an
event has occurred.
Event Log
The two event logs record and display events the system has
undergone since the last arming.
Exit Delay
See Delay
F
Fire Zone
A dedicated zone type for verified fire applications. Tripping this zone
generates an audible alarm with a distinctive bell pattern.
Follow-Me
A method of monitoring the system without connecting to a central
station based monitoring service. In the event of an alarm, the panel
dials the follow-me number and sounds a number of tones via the
telephone.
Forced Arming
Arming before the system is ready. If zones are still open when the exit
delay has expired an alarm will be generated.
I
Immediate Arming
Arming the system without an exit/entry delay.
Installer Code
The code which grants access to programming mode.
Interior Zone
A zone that is not armed during Stay arming
K
Keypad Trouble
Condition brought about by improper definition of keypads or if a
keypad has been disconnected.
Keyswitch
Peripheral device connected to the tamper zone for arming and
disarming the system by the turn of a key.
L
Latching
One of the two keyswitch function modes. A latching keyswitch toggles
the system to arm or disarm by one turn of the key
(On or Off=Arm/Disarm).
Log
See Event Log
Low Battery
Condition brought about if the voltage supplied to the backup battery
deteriorates to approximately 10.5V or less.
M
Magnetic Contacts
Peripheral device mounted on doors incorporating a magnet that
closes a circuit. Opening the door breaks the circuit and opens the
zone to generate an alarm.
Master Code
The only user code with the ability to program other user codes.
Momentary
One of the two keyswitch function modes. A momentary keyswitch
toggles the system to arm or disarm by turning the key on and off.
(On & Off=Arm or Disarm).
P
Perimeter Zone
Perimeter zones are armed during both regular and Stay arming and
can be defined with or without an exit delay.
Periodic Test
The periodic test event code is sent to the central station every 24
hours to indicate that the system is functional.
PGM Output
Programmable output for connecting additional system status indicators.