User's Manual

ManualsBrandsElectronics Tomorrow Manualsalarm clocks433MHz RF Receiver Alarm Clock

Feature

 Calendar with day of the week display from January 1, 2003 to December 31, 2069

 Hour and minute display

 12 or 24-hour format

 Indoor temperature and remote temperature

 Centigrade or Fahrenheit readout

 Battery life : approximate 1 year with alkaline batteries ( not included )

 Clock operating temperature from 0°Cto 50°C ( 32°F to 122°F )

 Indoor, Outdoor Temperature measuring range from -20°C to 60°C (-4°F to 140°F )*

 Temperature resolution 0.1°C

*If using the wireless transmitter with temperature below 32°F or above 122°F, user are recommended to

use Lithium battery to enhance batteries life

Location of Controls

Summary of content (7 pages)

PAGE 1
Feature Calendar with day of the week display from January 1, 2003 to December 31, 2069 Hour and minute display 12 or 24-hour format Indoor temperature and remote temperature Centigrade or Fahrenheit readout Battery life : approximate 1 year with alkaline batteries ( not included ) Clock operating temperature from 0°Cto 50°C ( 32°F to 122°F ) Indoor, Outdoor Temperature measuring range from -20°C to 60°C (-4°F to 140°F )* Temperature resolution 0.
PAGE 2
Getting Start Batteries Installation Batteries installation of the clock Insert 2 “AA” batteries in polarity (+) and (-) as indicated Close the battery cover The low battery icon will show in the clock window when your batteries need replacing Batteries installation of wireless transmitter Insert new batteries into clock Insert 2 “AA” size batteries in proper polarity (+) and (-) as indicated Close the battery door Warning : Do not mix old and new batteries Do not mix alkaline, standard ( carbon-zinc ), or
PAGE 3
minutes. The RF Temperature signal indicator in the clock’s outdoor temperature window will show the following: Interference Signals from other household devices, such as entry controls, door bells and home security systems, may temporarily interfere with the clock and cause reception failure. This is normal and does not affect the general performance of the product. The transmission and reception of temperature reading will resume once the interference has stopped. Setting the Clock 1.
PAGE 4
3. To deactivate the alarm function, slide the SNZ/ON/OFF ALM switch to OFF position. To Activate the snooze alarm 1. Slide the SNZ/ON/OFF ALM switch to SNZ position. The sign and will appear on the time display. 2. When the alarm sounds, press the snooze/light bar. The alarm will sound again in approximately 5 minutes. You may repeat this function for 10 minutes. 3. To deactivate the snooze alarm slide the SNZ/ON/OFF ALM switch to the OFF position.
PAGE 5
However, this depends on the surrounding environment and interference levels. The temperature signal travels in a straight line from the transmitter to the clock. The signal will not curve around blocking object. Each will or floor the signal must pass through is equal to approximately 20 feet of open space. If no reception is possible despite the observation of these factors, all system units have to be reset ( see Getting Started ).
PAGE 6
Warranty This product is warranted to be free of defects in manufacturing for 1 year after purchase. Defective clock should be returned to the place of retail purchase. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance cound void the user’s authority to operate the equipment. NOTE: This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules.
PAGE 7
Indoor: 2 “AA” batteries, 1.5V batteries Outdoor: 2 “AA” batteries, 1.5V batteries Battery life: about 12 months Dimension ( LxWxH ) Indoor: 13.2x7.9x6.3cm Outdoor: 10x7x2.