Owner manual

ELECTRONICS INCORPORATED

SHOT PEENING TECHNOLOGY

MODEL 577-24 MagnaValve

www.electronics-inc.com

577-24data.pub 5/18/09

999289

The Model 577-24 MagnaValve is a normally closed magnetic valve suitable for

regulation of steel shot and includes a built-in sensor for accurate measurement of flow

rate. Used with the Model FC-24 Shot Flow Controller, the MagnaValve will provide

accurate and repeatable flow rates over a 1 - 10 pounds-per-minute flow range. The

577-24 MagnaValve can be re-calibrated for various shot types and sizes for higher

accuracy.

The valve construction includes a permanent magnet for normally closed operation

and an electromagnet for controlling shot flow rates. By regulating the voltage to the

electromagnet, any desired flow rate may be achieved. When power is off, the valve

will hold shot due to the permanent magnet.

The Model 577-24 MagnaValve incorporates a preamplifier circuit to allow for high

noise immunity and a 0-10 Vdc output. The valve is factory calibrated and results are

included upon request. Note: consult factory for pre-calibration using media other than

cast steel shot.

 High Accuracy - ±5% of FS

 Built-in flow sensor

 1 - 10 lbs/min range

 Normally closed

 Requires FC - 24 Flow Controller

 Air type shot peening machines

 Variable flow rates

 No moving parts

 Steel shot or Steel grit

 With 6’ Cable

PAGE 1
MODEL 577-24 MagnaValve 999289           High Accuracy - ±5% of FS Built-in flow sensor 1 - 10 lbs/min range Normally closed Requires FC - 24 Flow Controller Air type shot peening machines Variable flow rates No moving parts Steel shot or Steel grit With 6’ Cable The Model 577-24 MagnaValve is a normally closed magnetic valve suitable for regulation of steel shot and includes a built-in sensor for accurate measurement of flow rate.
PAGE 2
MODEL 577-24 MagnaValve SPECIFICATIONS Sensor Display LED’s: Valve ON Command input Enable +24V Power Output: 0 - 10Vdc Adjustments: Zero Span Pulse Rate Accuracy: +/- 5% (of full scale) Control Input: 0-10Vdc Into 100K Enable: 24Vdc @ 10mA Valve Power: +24Vdc @ 2A (50VA) Calibration: 1 - 10 lbs/min Media: Steel shot Max. Pressure: 100 PSI Mode: Normally closed Temp. Range: 40-110° F 5-43° C ZERO (Factory set) 3 SPAN (Factory set) 4 2 FRONT VIEW (COVER REMOVED) 5 1 6 1.