User guide

ELECTRONICS INCORPORATED

SHOT PEENING TECHNOLOGY

MODEL 590-24 MagnaValve

www.electronics-inc.com

590-24data.pub 4/25/2008

999293

 High Accuracy - ±5% of FS

 Built-in flow sensor

 30 - 300 lbs/min range

 Normally closed

 Requires FC - 24 Flow Controller

 Air type shot peening machines

 Variable flow rates

 No moving parts

 Steel shot or Steel grit

 Includes 6’ Cable

The Model 590-24 MagnaValve is a normally closed magnetic valve suitable for the

regulation of steel shot. The Model 590-24 includes a built-in sensor for accurate

measurement of flow rate. Used with the Model FC-24 Shot Flow Controller, the 590-24

MagnaValve will provide accurate and repeatable flow rates over a 30 to 300 pounds-

per-minute flow range. The 590-24 MagnaValve is factory calibrated for various shot

types and sizes for higher accuracy. Please be sure to specify the type and size of shot

you plan to use.

The valve construction includes a permanent magnet for normally closed operation and

an electromagnet for controlling shot flow rates. By regulating the voltage to the

electromagnet, any desired flow rate may be achieved. When power is off, the valve will

hold shot due to the permanent magnet.

The Model 590-24 Magnavalve incorporates a preamplifier circuit to allow for high noise

immunity and a 0-10 Vdc output. The valve is factory calibrated and results are included

upon request.

Note: consult factory for pre-calibration using media other than cast steel shot.

PAGE 1
MODEL 590-24 MagnaValve 999293           High Accuracy - ±5% of FS Built-in flow sensor 30 - 300 lbs/min range Normally closed Requires FC - 24 Flow Controller Air type shot peening machines Variable flow rates No moving parts Steel shot or Steel grit Includes 6’ Cable The Model 590-24 MagnaValve is a normally closed magnetic valve suitable for the regulation of steel shot. The Model 590-24 includes a built-in sensor for accurate measurement of flow rate.
PAGE 2
MODEL 590-24 MagnaValve 999293 SPECIFICATIONS Sensor Display LED’s: Valve ON Command input Enable +24V Power Output: 0 - 10Vdc Adjustments: Zero Span Pulse Rate Accuracy: +/- 5% (of full scale) Control Input: 0-10Vdc Into 100K Enable: 24Vdc @ 10mA Valve Power: +24Vdc @ 2A (50VA) Calibration: 30 - 300 lbs/min Media: Steel shot Max. Pressure: 100 PSI Mode: Normally closed Temp.