Owner manual
LP-24 MagnaValve®
Magnetic Valve for Wheel Machine Applications
Features
• Flow rate range of 400 - 2000 lb/min (181 - 907 kg/min)*
• Flow control for wheels up to 50 Hp (37 kw)
• Normally closed
• No moving parts for maintenance-free operation
• Provides controllable shot ow rates
• Regulates ow of steel shot and grit
• Easy retrot installation
• Diagnostic LEDs for 24 Vdc Power, Enable Command,
Flow Input Signal and Shot Flow
* Flow rates are based on S230 shot
Description
The LP-24 MagnaValve® is a normally closed magnetic valve that regulates the ow of steel shot and grit in wheel
blast machines. The LP-24 is maintenance free — it has no moving parts so there are no parts to wear or break and it
is completely sealed to prevent media dust from entering the valve. The LP-24 has rare earth permanent magnets for
normally closed operation and an electromagnet for controlling shot ow rates. With power applied, the magnetic
eld is neutralized and shot is allowed to ow through the valve. When no power is applied to the MagnaValve, the
permanent magnets stop all ow. If the power is interrupted for any reason, the permanent magnets securely
hold the shot, thereby virtually eliminating shot leakage.
For an “automatic” closed-loop operation, an Electronics Inc. AC-24 Controller will detect the current load on
the wheel motor and regulate the ow of media to the LP-24. This closed-loop system will provide accurate
and repeatable ow rates over a 400 - 2000 lb/min (181 - 907 kg/min) range. The EI POT-24 Controller (sold
separately) provides “manual” open loop control. Data sheets available for download at www.electronics-inc.com: AC-24
Controller, POT-24 Controller
A clear and comprehensive installation manual simplies installation of the LP-24 MagnaValve. The valve is
factory tested and results are supplied upon request. In addition, the products are supported by the EI
application engineering sta.
Electronics Inc.
56790 Magnetic Drive
Mishawaka, Indiana 46545 USA
(574)256-5001
http://www.electronics-inc.com
Rev 4/13
MagnaValve is a registered trademark of Electronics Inc.
AC-24
Controller
Regulated Media Flow
Control Signal
Desired
Motor Current
Motor
Current
Ammeter
Media Accelerated
Media
Hopper
MagnaValve
Wheel
Pot-24
Controller
Regulated Media Flow
Control Signal
Motor
Current
Ammeter
Media Accelerated
Media
Hopper
LP-24
MagnaValve
Wheel
Desired
Motor Current
Closed Loop System with LP-24 MagnaValve and AC-24 Controller Open Loop System with LP-24 MagnaValve and POT-24 Controller
AC-24 Controller
(sold separately)