Operating Instructions

January 8, 2021

GTW-BL100 Wireless Gateway

DEPLOYMENT

1. Program the Gateway (Node) ID and MQTT Broker IP address into the Gateway.

2. Connect the 2.4 GHz antenna to the Gateway.

3. Plug the DC input power to the Gateway. The gateway defaults to power ON. The orange PWR LED

will turn ON, and the red Fault LED will start to blink at 2 second intervals. You may also see the red

COM LED ash at 5 second intervals.

4. Plug in the Ethernet cable. The Gateway will automacally aempt to establish connecon to a

MQTT Broker at the IP address programmed into the Gateway. Once connecon is established, the

Fault LED on the front panel membrane will go out. Note that a green LED on the Gateway circuit

card may be visible through the boom of the enclosure.

5. Gateway is now ready to pair with Bluetooth sensors and to handle data trac.