Operating Instructions

January 8, 2021
GTW-BL100 Wireless Gateway
4
FCC COMPLIANCE AND ADVISORY STATEMENT
This device complies with Part 15 of the FCC rules. Operaon is subject to the following two condions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired
operaon.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protecon
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instrucon manual, may cause harmful interference to radio communicaons.
Operaon of this equipment in a residenal area is likely to cause harmful interference in which case
the user will be required to correct the interference at his own expense.
Any changes or modicaons not explicitly approved by Electronics4All Inc. could cause the device to
cease to comply with FCC rules Part 15, and thus void the user's authority to operate the equipment.
INDUSTRY CANADA COMPLIANCE AND ADVISORY STATEMENT
Operaon is subject to the following two condions: (1) This device may not cause interference, and
(2) this device must accept any interference, including interference that may cause undesired operaon
of the device.
Son fonconnement répond aux condions suivantes: (1) l'appareil ne provoquera aucune interférence
nocive et (2) l'appareil tolère toutes les interférences reçues, y compris les interférences qui ont pour
conséquence des réacons non souhaitables.
SAFETY INFORMATION
1. Operate the device only with the specied antenna and AC/DC adapter. See the Specicaons
secon for approved accessories.
2. The device is intended for use only in a clean and dry indoor environment.
3. Always wear personal protecve equipment appropriate to the environment where the device is
installed and operated.
4. In the event of an emergency, disconnect the DC power plug from the device.
5. The device contains no user serviceable parts. Do not aempt to repair the unit. See the Contact
Informaon secon for support or repair.
INSTALLATION
PROFESSIONAL INSTALLATION
The GTW-BL100 wireless gateway is designed specically to operate within an electric power
generang facility. Incorrect installaon or conguraon of the gateway may result in unsasfactory
performance of either the gateway or the wireless sensors paired to the gateway. As such, only
authorized personnel should be permied to install, congure, and access the wireless gateway.