Maintenance Guide Part 4

NeTIS MAINTENANCE GUIDE – Version 1.1 112/139
As above, authentication is carried out by a technician from the authentication centre or the
customer who will use another menu on the authentication network management terminal. It
must be connected to Internet and the equipment at the same time. If this is not possible the
new software key can be retrieved directly from the Internet and the equipment authenticated
using the technique described in the previous paragraph.
9.6 Handling
9.6.1 G ENERAL
9.6.1.1 Introduction
The authentication network management terminal is used to authenticate via internet i.e. to
reference and unblock equipment manufactured by Etelm. After having entered the
parameters, either the network management terminal connects to the authentication centre and
downloads a new key to replace the old one, or the new key is entered manually after having
been exchanged for the old key by phone. The network management terminal then sends the
key to the equipment via the network or the RS232 port (serial) depending on the user's
choice.
9.6.1.2 Procedure
When the network management terminal is launched the following window appears. A menu
gives access to a few settings such as the language, help or the choice of the authentication
technique. Clicking on the image either launches automatic authentication (the globe) or
manual authentication (the telephone).
Automatic or manual authentication choice menu
Whatever the previous selection, the following window is displayed (except for what is
outlined in red which only appears for automatic authentication):