Maintenance Guide Part 4

NeTIS MAINTENANCE GUIDE – Version 1.1 114/139
To finish click on the "connect" button and the network management terminal attempts to
retrieve the key.
A small window shows the status of events (connection, disconnection and error). The
diagram shows a network management terminal and a BS connected by a cable. The cable is
green when connected and red otherwise. In the following case the connection succeeded (in
the window and the cable is green) and the old key is shown in the "previous key" field.
Typically the authentication network management terminal waits for the new key in order to
send it to the equipment.
In the progress window (at the bottom) there are several items that can be very useful. The
type of software that can be used to make sure there is no error, the version is used to know if
the software is up to date and finally if the equipment is already authenticated. In the example
below a TETRA version 2.0j switch has already been authenticated.
Manual authentication menu using a network cable