Instructions / Assembly

Questions?
E-mail our customer service department at
[e-mail]
IMPORTANT SAFETY INSTRUCTIONS:
ASSEMBLY INSTRUCTIONS:
CLEANING
&
MAINTENANCE
:
This fixture must be installed by a
qualified electrician!
Disconnect the power at the main
electrical panel before installation.
This fixture is for indoor use only. The
fixture should not be used near water.
Never cover the lamp with any object,
including cloth or paper as this is a fire
hazard. Do not handle the bulb
immediately after the light is turned off
as it will be hot. This is not a toy. It is
recommended that you wear gloves
during assembly.
1. TURN THE MAIN POWER SUPPLY OFF
2. ATTACH THE MOUNTING PLATE"E" TO
THE ELECTRICAL BOX "G" WITH SCREWS
"C"
3. MAKE THE WIRE CONNECTIONS.
CONNECT BLACK TO BLACK WIRE AND
WHITE TO WHITE WIRE. ATTACH
GROUNDING WIRE (HAS A GREEN LINE
ON IT) TO THE MOUNTING PLATE "E"
GROUNDING SCREW "D"
4. ALIGN THE HOLES OF THE VANITY "B"
TO THE MOUNTING PLATE "E" , AND
SECURE THE VANITY WITH THE 2 NUTS
"A"
5. PLACE THE SHADE "H" ON THE SOCKET
, SECURE WITH SOCKET NUT "I".
6. INSTALL BULB INTO THE SOCKET .
ONLY USE BULBS OF SPECIFIED TYPE AND
MAXIMUM RATED WATTAGE OR LESS.
DO THIS SAME STEP FOR THE
REMAINING SOCKETS.
Instruction Manual
VANITY
BULB REPLACEMENT
Disconnect the power before replacing
bulb.
TROUBLESHOOTING
I. If lamp does not light, check the bulb
for a broken filament.
Replace bulb if necessary.
2. If the external flexible cable or cord of
this fixture is damaged, it must be
replaced by a qualified electrician in
order to avoid a hazard.
MAINTENANCE
I . To clean, use a soft, dry cloth only.
2. Do not use any chemical or abrasive
cleaners.
REQUIRES:
3-60W MAX TYPE A BULB (NOT
INCLUDED)