Installation Sheet

C O M P O N E N T PA R T S A N D F I T T I N G S
Safety Warning
IMPORTANT
PLEASE READ THE INSTRUCTIONS BEFORE SET UP AND INSTALLATION
Cabinet x1
Suggested Tools:
Drill
Screw driver
Screw & Wall plug x 4
(Included in pack)
Silicon plug x 20
(Included in pack)
Glass shelf bracket x 8
(Included in pack)
Hinge cover x 2
(Included in pack)
Wire nut x 3
(Included in pack)
M01 M04
M02
M03
M05
M07
Glass shelf x 2
(Included in pack)
Caution:
Safety:
• We suggest you spend a short time reading the instruction leaflet.
• Carefully check that you have all the parts before beginning assembly.
• Keep small parts and fittings out of children's reach and keep children well away from construction
area, as the unassembled product contains small parts, which could present a choking hazard.
• We suggest you retain these instructions for future reference.
• This appliance can be used by adults ONLY.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
• In order to avoid overheating, do not cover the mirror.
• Switch off the mains supply and remove the appropriate fuse or switch off the appropriate circuit
breaker before commencing installation
• Make sure that there is no danger that the cord or extension cord is inadvertently be pulled or cause
anyone to trip when in use.
Page 2
• Note that this is a hardwired installation and does not come with a power switch. Your electrician
must install the hardwired mirror to an electrical junction box to connect to a room light switch to
turn off or turn on the mirror.
Note that this mirror does not come with a dimmer.