User Manual

127 / 223
Example One
In this first example, the time delay is set to three seconds and the trigger mode is
set to single. As you can see in the illustration below, the motion is not always
detected. In fact, there is a period of about six seconds where motion can not be
detected. Feel free to click on the image to enlarge.
Example Two
In the next example, the time delay is still at three seconds and the trigger is set to
repeatable. In the illustration below, you can see that the time delay period is
restarted. However, after that three seconds, detection will still be blocked for
three seconds.
As I mentioned previously, you could override the 3 second blocking period with
some creative code, but do give that consideration. Some of the electronics you
use may not like an on and then off jolt. The three seconds allows for a little rest
before starting back up.