Band Saw Model BAS 500 WNB Instruction Manual

ManualsBrandsElektra Beckum ManualsSawBAS 500 WNB

115 168 8051 / 3602 - 1.0 de, en

Achtung! Lesen Sie diese Anleitung vor der Installation und Inbetriebnahme aufmerksam durch.

Attention! Carefully read through these instructions prior to installation and commissioning.

ENG

Betriebsanleitung Bandsäge

Operating Instructions for Band Saw

BAS 500 WNB

Summary of content (7 pages)

PAGE 1
Betriebsanleitung Bandsäge D ENG Operating Instructions for Band Saw 115 168 8051 / 3602 - 1.0 de, en BAS 500 WNB D ENG Achtung! Attention! Lesen Sie diese Anleitung vor der Installation und Inbetriebnahme aufmerksam durch. Carefully read through these instructions prior to installation and commissioning.
PAGE 2
PAGE 3
ENG GENERAL SAFETY INFORMATION 18. ADJUST BLADE TENSION, upper and lower blades guides, thrust bearings and blade tracking correctly. 19. DOORS AND BLADE GUARD must be in place and securely fastened when performing saw operations. 20. SECURELY LOCK ALL ADJUSTABLE PARTS so they can not loosen while sawing. This will prevent distraction from sawing operations. 21. PLACE THE BLADE GUARD to within 5 mm above the material to be cut. 22. USE THE PROPER BLADE TYPE AND SIZE for the material being cut. 23.
PAGE 4
function which results from improper use or unauthorized modification from standard specifications, faulty maintenance, damage or improper repair by anyone other than qualified persons approved by Elektra Beckum or its representatives. Elektra Beckum reserves the right to change specifications and design without prior notice and without incurring obligation of any kind. Equipment referred to as available or optional may be at extra cost.
PAGE 5
● Adjust the hex. head screw of the stop to set the table exactly square with the blade. ● After the stop is adjusted, stick the rip fence scale (89) to the rip fence carrier (201). 5 Band Saw Setup Blade Speed Change To change the cutting speed, the V-belts must be changed on the pulleys as shown in the table inside the lower wheel housing door. For an easy belt change a quick-action tensioning device is provided, actuated by the handwheel (20) at the lower right hand side of the wheel housing.
PAGE 6
Saw Table Tilt - For bevel cuts the table can be tilted up to 45°. Loosen the wing nut (135) of the table trunnion assembly, tilt the table to the required position and retighten the wing nut. Make trial cut in a piece of scrap wood to verify setting to desired angle. - Hand guards: Prior to tilting the two hand guards on the underside of the table must be moved towards the fence guide extrusion to clear the blade when the table is tilted.
PAGE 7
10 Dust collection 12 U.K. Supplement to Operating Instructions for Elektra Beckum Band Saw BAS 500 Caution! Dust of certain wood spezies is carcinogenic. ➜ When operating your woodworking machine indoors connect to a dust collector. ➜ If a woodworking machine is operated indoors for more than 30 minutes, it is mandatory to connect it to a dust collector. Please note the following supplementary information associated with this machine: U.K.